According to Moore’s law, the number of transistors on a chip roughly doubles every 2 years. As a result, the current technology accommodates more number of transistors; almost a billion. In System on Chip (SoC), the multiple processor & logic inside the chip are driven at high clock frequency, which in turn dissipates more power, especially at the clock edge. As these trends continue, the power dissipation will become more and more difficult to manage. This increasing power density makes the device more power sensitive in turn creates a huge problem related to heat dissipation. The heat dissipation is not uniform throughout the chip creating hot spots. Hot spots have adverse impact on the performance and reliability of the chip. Recent data shows that more than 50% of all IC failures are related to temperature issue. In this paper two different approaches (ring oscillator & leakage based inverter circuit) were tried out to measure the sensitivity of the dynamic temperature variations. The proposed leakage current based circuit has given dimensionless sensitive value equal to 0.7957 in the scale down technology when compared to ring oscillator dynamic temperature sensor which is 0.076 which is almost 10 times less than of leakage. The other advantage of the leakage current based circuit is it can be built with minimum number of transistors. This circuit can be used in large number to measure the temperature through the chip and integrated to control the area were the heat dissipation is more. The entire set up is simulated and verified in 180ɳm & 45ɳm technological libraries from TSMC to check the scalability

System on Chip (SoC), TSMC, threshold voltage, mobility sub threshold current, drain current and saturation velocity

[1] Yi Ren,Chenxu Wang, Hong Hong “An all CMOS temperature sensor for thermal monitoring of VLSI Circuits”, in the proceedings of the 2009 International Conference on Testing and Diagnosis, Chengdu, China.
[2] Kameswar Rao Vaddina, Liang Guang, Ethiopia Nigussie, Pasi Liljiberg and Juha Plosila “On-line Distributed Thermal Sensing and Monitoring of Multicore Systems”, NORCHIP (2008), pp. 89-93.
[3] Basab Datta, Dhruv Kumar “Analysis of a Ring Oscillator based on Chip Thermal sensor in 65 nm Technology”, University Of Massachusetts-Amherst.
[4] Basab, Datta, Wayne Burleson “Calibration of on-Chip Thermal Sensors Using Monitoring Circuits”, in the proceedings of the 2010 International Symposium on Quality Electronic Design (ISQED).
[5] Ashish Syalt, Victor Lee, Andre Ivanov T, Josep Altet “CMOS Differential and Absolute Thermal Sensors” in the proceedings of 2001 seventh International On-Line Testing workshop, pp: 127 - 132.
[6] Shekhar Borkar “Design challenges of scaled technology” Intel Corporation, 1999, pp 23-29.
[7] Nitin Sachdeva, Neeraj Julka “Effect of Temperature Fluctuations on MOSFET Characteristics” Internationa Journal of Electronics & Communication Technology Vol. 2, Issue 1, pp: 75-78, 2011.
[8] Poki Chen, Member, IEEE, Chun-Chi Chen, Chin-Chung Tsai, and Wen-Fu Lu “A Time-to-Digital-Converter-Based CMOS Smart Temperature Sensor” IEEE Journal Of Solid-State Circuits, Vol. 40, issue 8, pp. 1642 – 1648, 2005.
[9] K.G. Verma Dr. Brajesh Kumar Kaushik Dr. Raghuvir Singh “Analysis of Propagation Delay Deviation under Process Induced Threshold Voltage Variation” International Journal of Computer Applications Vol. 17 issue.5, pp. 20-25, 2011
[10] Dusung Kim and Jiseok Kim “Temperature dependent leakage sensors using specially designed DRAM cells”.
[11] John F. Wakerly, “Digital Design- Principles and Practices”, fourth edition. Pearson,